Description: 把程序写进单片机从而控制电梯的上下，开关门，报警等功能！这个程序简单，使用性强！-procedures written into the MCU control of the elevator up and opening the doors, alarm functions! This simple procedure, the use of strong! Platform: |
Size: 1954 |
Author:士大夫 |
Hits:
Description: 把程序写进单片机从而控制电梯的上下，开关门，报警等功能！这个程序简单，使用性强！-procedures written into the MCU control of the elevator up and opening the doors, alarm functions! This simple procedure, the use of strong! Platform: |
Size: 2048 |
Author:士大夫 |
Hits:
Description: 设计一个６层自动升降电梯的控制电路，该控制器可控制电梯完成６层楼的载客服务，且遵循方向优先原则，同时指示电梯运行情况和电梯内外请求信息，具体要求如下：
（１）每层电梯入口处设有上、下请求开关，电梯内设有乘客到达楼层的请求开关。
（２）设有电梯所处楼层指示、电梯运行模式（上升或下降）指示。
（３）电梯的上升和下降的时间均为2s。
（４）电梯到达停站请求后，开门时间为4s，关门时间为3s，可以通过快速关门信号和关门中断信号控制关门。
（５）能记忆电梯内、外的所有请求信号，并按照电梯运行规则次序响应。响应动作完成后清除请求信号。
（６）能检测是否超载，并设有报警信号。
（７）方向优先规则：当电梯处于上升模式时，只响应比电梯所在位置高的上楼请求信息，由下而上逐个执行，直到最后一个上楼请求执行完毕；若更高层有下楼请求，则直接到有下楼请求的最高层接乘客，然后进入下降模式。电梯处于下降模式时，与上升模式相反。
-Design of a six-layer automatic elevator control circuit, the controller can control the complete six-story elevator passenger service, and follow the direction of the priority principle, direct the operation of the elevator and the elevator inside and outside the requested information, the specific requirements are as follows:
(1) on each floor with elevator entrance, a request under switch, equipped with a passenger elevator to reach the floor request switch.
(2) floor with elevator in which direction, the lift operation mode (up or down) direction.
(3) elevators rise and fall times are 2s.
(4) the lift reached the stop request, the opening hours for the 4s, closing time for the 3s, can be quickly closed and closed interrupt signal control signal to close.
(5) can remember the elevator, all requests outside of the signal, and in accordance with rules of order elevator response. Response action is completed, clear request signal.
(6) can detect overload, and has an alarm s Platform: |
Size: 262144 |
Author:wyj |
Hits:
Description: 1．该设计是一个6层自动升降电梯的控制电路；
2．每层电梯入口处设有上下请求开关，电梯内设有乘客到达楼层的请求开关；
3．设有电梯所处楼层指示和电梯运行模式指示；
4.电梯的上升和下降时间均为2秒；
5.电梯到达停站请求后，开门时间为4秒，关门时间为3秒；
6.能记忆电梯内外的所有请求信号，并按照电梯运行规则次序响应，响应动作完成后清除请求信号；
7.能检测是否超载，并设有报警信号；
8.方向优先规则：当电梯处于上升模式时，只响应比电梯所在位置高的上楼请求，有下而上逐个执行，直到最后一个上楼请求执行完毕，因此更高层有下降请求则直接到有下楼请求最高层接客，然后进入下降模式。电梯处于下降模式时，与上升模式相反。-A. The design is a six-layer control circuit of the automatic elevators Each floor elevator entrance. Up and down a request to switch, elevator equipped with a passenger to reach the floor request switch Floor with elevator in which instructions and lift mode of operation instructions elevator rise and fall times are 2 seconds 5. The elevator to stop at the stations to request the opening hours for 4 seconds, the closing time of 3 seconds can memory elevator inside and outside the request signal, and in accordance with the order of the rules of operation of the lift response, the response action is complete, clear request signal 7 can detect overload, and has an alarm signal 8. direction priority rule: When the elevator in a rising mode respond only to requests than the elevator location upstairs, under the previous one by one implemented until the last one upstairs request completed, so the higher-level decline the request directly to the downstairs and request the most senior Platform: |
Size: 8192 |
Author:xuling |
Hits:
Description: 电梯的vhdl设计，6层楼含开开关门，警报，内部请求，外部请求
-Vhdl elevator design, six floors including the opening and closing the door, the alarm, the internal request, external request Platform: |
Size: 162816 |
Author:干预 |
Hits:
Description: 六层电梯控制，与实际电梯的运行逻辑一致，开门后5s自动关门（注：无快速关门和开门功能）-Six-story elevator control, consistent with the actual logic of operation of the elevator opened the door automatically closed (Note: No quick closing and opening function 5s) Platform: |
Size: 784384 |
Author:樊旭 |
Hits:
Description: 电梯模拟系统问题描述：
模拟某校九层教学楼的电梯系统。该楼有一个自动电梯，能在每层停留。九个楼层由下至上依次称为地下一层、第一层、第二层、……第八层，其中第一层是大楼的进出层，即是电梯的“本垒层”，电梯“空闲”时，将来到该层候命。
乘客可随时地进出于任何层。对于每个人来说，他有一个能容忍的最长等待时间，一旦等候电梯时间过长，他将放弃。
模拟时钟从0开始，时间单位为0.1秒。人和电梯的各种动作均要消耗一定的时间单位（简记为t），比如：有人进出时，电梯每隔40t检测一次，若无人进出，则关门；关门和开门各需要20t；每个人进出电梯均需要25t；如果电梯在某层精致时间超过300t，则驶回1层候命-Description of the problem:
Simulation of a school nine-story classroom building elevator system. Even an escalator at each stay. Nine floors from bottom sequentially called underground layer, the first layer, the second layer, ...... eighth layer, wherein the first layer is the building of the access layer, that is, the home base layer "of the elevator, the elevator" idle "will come to the layer on standby.
Passengers and out at any time in any layer. For each person, he has a tolerance longest wait time, waiting for the elevator too long, he will give up.
Analog clock from 0, the unit of time is 0.1 seconds. And lift a variety of actions have to consume a certain amount of time units (abbreviated as t), such as: was out, elevator every 40t detection, time, if not the movement of people, closed closing and opening each 20t each individuals out of the elevator are 25t elevator in a layer of fine more than 300t, drove back a layer on standby Platform: |
Size: 6144 |
Author:张坤 |
Hits:
Description: 电梯程序。等候电梯队列采用链表，每进一个人增加一个结点。电梯则用结构体，包括多个参数。函数包括，主函数,opening(),opened(),waiting(),closing(),closed(),moving(),ran_floor()(随机产生等待电梯的人)-Lift program. Waiting for the elevator queue using linked lists, each into a person to add a node. Elevator structural body including a plurality of parameters. Functions, including the main function, opening (), opened (), waiting (), the closing (), closed (), moving (), ran_floor () (randomly generated waiting for the elevator) Platform: |
Size: 5120 |
Author:陈宝 |
Hits:
Description: 七层电梯设计基于labview设计，编程简单易懂，有动画设计，开关门设计。(The design of the seven-floor elevator is based on labview design. The programming is simple and easy to understand. There is animation design and door opening and closing design.) Platform: |
Size: 1813504 |
Author:男安安 |
Hits:
Search - Elevator opening